Click on the line you want to project and press 'p' on your keyboard to project the line.

However, we do not want to draw a line now but project the leading line created in 'Step 2'. Now create a sketch on the level created in 'Step 5'.

Step 6: Main sketch for of the creating Hole.

Pull the plane far enough out of the part so that the hole can completely cut through the part and not just partially. So that when creating the bore and the danze Druchmesser is discharged from the part, we must create an offset level.

To check if the angle is right just type 'i' on you Keyboard for the measurement-tool and measure the angle between your plain and the line of the sketch in 'Step 1'.Īs you could see the angle is 90° so its time for Step 5 -) Set the angle in 90° to the line of your sketch in 'Step 1' as you could see in below pic. In this Step you have to use a plane and set it in an angle tho the sketch in 'Step 2' for this you have to use the the button which you see below.

Important is that you connect the line with the endpoint of your last sketch (point is highlighted on the pic below). Now you simply have to sketch a line on the surface the hole should be (marked blue on the pic below). Here you could see the the Hole in the middle of the part from below side Sketch a line with the Direction and the wanted angle of the hole you want to model from the edge on the surface she should start.Īt the picture below you see i want to hit the first hole and the hole in the middle of the Part (dashed line) If you have any questions, ideas for other tutorials or suggestions do not hesitate to contact me. Here I explain how to construct holes in Fusion360 at an angle on an angled surface.

Fusion 360 loft with hole