This does, however, work 100% of the time if done in the attack confirmation box. If you do it while you are in the city, pay attention to the units displayed on the attack confirmation box. The other 20% is the chance the AI will randomize it yet again before you confirm your attack. Notes: It works 80% of the time if you are doing it in the city. It should look like this…Īnd for proof, here is a screen shot of the battle that ensues after! What is obvious from the spreadsheet, however, is that once you surpass a 20:1 attack to defense ratio (attack value of your unit vs defense value of opposing unit), you are guaranteed a 1-hit kill on the opposing unit unless the unit has extra health or a special ability that reduces damage. Remove all of your desired units like in the screen shot below.ģ) And finally, simply select the removed units and move them back into your army configuration! Units that recently have entered the army configuration will go first unless another unit has a higher speed value. Don’t worry, as 99% of you already know, it will prompt a confirmation with which it allows you to make final minute army set-up. I want my Crossbowman to start first so that it’s high damage gets dished out first.Ģ) Go to your campaign map, and select a province. This is all a very easy process which requires no more than a minute.ġ) First, you have an army like the picture below. Some people may already know this trick, however, others are stuck with it. Please keep in mind that it works ONLY with units of the same speed value but of different tiers, as you would rather have a Trebuchet go first than a Ballista you have yet to replace. I have seen many people complaining about how the AI randomly chooses whatever units will start first in your army during a battle. Forge of Empires Choosing Units to Attack First Guide by Surge

Forge of empires auto battle calculator